Search This Blog

Wednesday, August 29, 2018

Chimneys should be inspected after recent storm

By Marge Padgitt



Some of the lightning strikes throughout the greater Kansas City area last night hit chimneys. 

A lightning strike caused major
damage to this chimney exterior
and interior
Pieces of bricks on the ground and roof, or blown out sections of a chimney are signs that a recent event occurred and the chimney may have been hit by lightning.

In some cases the damage is so severe that the chimney must be torn down and rebuilt. In other cases where there are only a few damaged bricks or stones these can be removed and replaced with new bricks.

When lightning strikes a chimney the evidence is usually obvious. There is always an entrance and exit point. The entrance point, usually found near the top of the structure, will likely be a large hole with burn marks, and may include large cracks through the masonry or blown out sections of stones or bricks. The exit point is usually found somewhere within the chimney structure in the flue, smoke chamber, firebox, or even the outer hearth inside the house.

Damage not so visible from the ground -
lightning hit the top of the chimney and
pushed a brick out on the back side
A professional chimney inspector should examine any chimney that has been damaged by lighting. The chimney sweep should perform a Level II internal chimney inspection with a chimney camera system in order to see if any interior damages have occurred which make the fireplace, furnace, or water heater flue unusable. Only persons trained specifically on chimneys can identify chimney damages properly and provide the needed documentation for an insurance claim. 


_____________________________________________________
Marge Padgitt is the president and CEO of HearthMasters, Inc. dba Padgitt Chimney & Fireplace. She is a CSIA Certified Chimney Sweep and NFI Certified Wood- burning Specialist. Contact Marge at hearthmastersboss@gmail.com.

Friday, August 24, 2018

Cut utility bills by using wood-heating appliances


Cut utility bills by using wood-heating appliances

Fireplace insert by Regency
One way to cut utility bills during cold weather is to use a wood-fired heating appliance such as a masonry heater, wood-burning stove, or wood-burning fireplace insert. 


Freestanding wood-burning stove
by Regency

Today’s modern wood-burning heating appliances are very efficient and clean-burning, unlike their older predecessors. The Environmental Protection Agency regulates wood stove emissions and has strict requirements that stove manufacturers must follow. This is why replacing an older, dirty burning wood stove is good not only for the environment, but less wood is needed to produce the same amount of heat.

Fuel costs can be significantly less than oil, gas, or electric heating appliances, especially if there is a nearby supply of inexpensive cordwood. For homeowners with their own land and trees, the concept of no cost for fuel other than physical exertion is very attractive. For those wanting to live off-grid, have an emergency heating alternative, or just lower fuel costs, the addition of a wood-burning appliance is a good solution.

Masonry Heater by Gene Padgitt
Masonry heaters are arguably the best type of wood-burning appliance. They use old-world technology which is a series of channels installed inside the appliance that trap heat, then transfer the heat slowly through the mass of masonry. Masonry heaters are large and need to be centrally located for maximum benefit. The Masonry Heater Association of North America has more information on these efficient site-built appliances.

Fireplace inserts are appliances that are installed inside an existing masonry fireplace. They use a small stainless steel flue liner and can be used either with or without a blower. By installing a new efficient wood-burning fireplace insert the fireplace efficiency will be increased by approximately 75%.

Freestanding stoves are appliances that are placed in a room and use an existing masonry chimney with a stainless steel flue liner or an independent Class A stainless steel chimney. These types of appliances are also highly efficient.

For more information on fuel cost calculators visit http://www.epa.gov/burnwise/woodstoves.html
____________________________________

Marge Padgitt is the president of HearthMasters, Inc. in Kansas City, Missouri. Contact her at hearthmastersboss@gmail.com. HearthMasters website is www.chimkc.com